Specifications

config ipif
Purpose Used to configure the System IP interface.
Syntax config ipif <ipif_name 12> [ ipaddress <network_address> | vlan <vlan_name 32> | state
[enable | disable] | bootp | dhcp}]
Description This command is used to configure the System IP interface on the Switch.
Parameters <ipif_name 12> - Enter the previously created IP interface name desired to be configured.
ipaddress <network_address> – IP address and netmask of the IP interface to be configured.The address and
mask information can be specified using the traditional format (for example, 10.1.2.3/255.0.0.0 or in CIDR
format, 10.1.2.3/8).
vlan <vlan_name 32> – The name of the VLAN corresponding to the previously created IP interface. If a primary
and secondary IP interface are configured for the same VLAN (subnet), the user cannot change the VLAN of
the IP interface.
state [enable | disable] – Allows you to enable or disable the IP interface.
bootp – Allows the selection of the BOOTP protocol for the assignment of an IP address to the Switch’s System
IP interface.
dhcp – Allows the selection of the DHCP protocol for the assignment of an IP address to the Switch’s System
IP interface.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure the IP interface System:
AT-9724TS:4# config ipif System ipaddress 10.48.74.122/8
Command: config ipif System ipaddress 10.48.74.122/8
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
enable ipif
Purpose Used to enable an System IP interface on the Switch.
Syntax enable ipif {<ipif_name 12> | all}
Description This command will enable the IP interface function on the Switch.
Parameters <ipif_name 12> – The name of a previously configured IP interface the user wishes to enable. Enter an
alphanumeric entry of up to twelve characters to define the IP interface.
all – Entering this parameter will enable all the IP interfaces currently configured on the Switch.
Restrictions None.
Example usage:
To enable the ipif function on the Switch:
AT-9724TS:4# enable ipif s2
Command: enable ipif s2
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
118
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual