Specifications

config lacp_port
Purpose Used to configure settings for LACP compliant ports.
Syntax config lacp_port <portlist> mode [active | passive]
Description This command is used to configure ports that have been previously designated as LACP ports (see create
link_aggregation).
Parameters <portlist> – Specifies a range of ports to be configured.The port list is specified by listing the lowest switch
number and the beginning port number on that switch, separated by a colon.Then the highest switch number,
and the highest port number of the range (also separated by a colon) are specified.The beginning and end of
the port list range are separated by a dash. For example, 1:3 specifies switch number 1, port 3. 2:4 specifies
switch number 2, port 4. 1:3-2:4 specifies all of the ports between switch 1, port 3 and switch 2, port 4 – in
numerical order.
mode – Select the mode to determine if LACP ports will initially send LACP control frames.
active – Active LACP ports are capable of processing and sending LACP control frames.This allows LACP
compliant devices to negotiate the aggregated link so the group may be changed dynamically as needs require.
In order to utilize the ability to change an aggregated port group, that is, to add or subtract ports from the
group, at least one of the participating devices must designate LACP ports as active. Both devices must support
LACP.
passive – LACP ports that are designated as passive cannot initially send LACP control frames. In order to allow
the linked port group to negotiate adjustments and make changes dynamically, at one end of the connection
must have “active” LACP ports (see above).
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure LACP port mode settings:
AT-9724TS:4# config lacp_port 1:1-1:12 mode active
Command: config lacp_port 1:1-1:12 mode active
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
114
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual