Specifications

config link_aggregation algorithm
Purpose Used to configure the link aggregation algorithm.
Syntax config link_aggregation algorithm [mac_source | mac_destination | mac_source_dest |
ip_source | ip_destination | ip_source_dest]
Description This command configures to part of the packet examined by the Switch when selecting the egress port for
transmitting load-sharing data.This feature is only available using the address-based load-sharing algorithm.
Parameters mac_source – Indicates that the Switch should examine the MAC source address.
mac_destination – Indicates that the Switch should examine the MAC destination address.
mac_source_dest – Indicates that the Switch should examine the MAC source and destination addresses
ip_source – Indicates that the Switch should examine the IP source address.
ip_destination – Indicates that the Switch should examine the IP destination address.
ip_source_dest – Indicates that the Switch should examine the IP source address and the destination address.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure link aggregation algorithm for mac-source-dest:
AT-9724TS:4# config link_aggregation algorithm
m a c _ s o u r c e _ d e s t
Command: config link_aggregation algorithm mac_source_dest
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
show link_aggregation
Purpose Used to display the current link aggregation configuration on the Switch.
Syntax show link_aggregation {group_id <value> | algorithm}
Description This command will display the current link aggregation configuration of the Switch.
Parameters <value 1-32> – Specifies the group ID.The Switch allows up to 32 link aggregation groups to be configured.The
group number identifies each of the groups.
algorithm – Allows you to specify the display of link aggregation by the algorithm in use.
Restrictions None.
Example usage:
To display Link Aggregation configuration:
AT-9724TS:4# show link_aggregation
Command: show link_aggregation
Link Aggregation Algorithm = MAC-source-dest
Group ID : 1
Master Port : 2:17
Member Port : 1:5-1:10,2:17
Active Port:
S t a t u s : Disabled
Flooding Port : 1:5
A T - 9 7 2 4 T S : 4 #
113
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual