Specifications

delete link_aggregation group_id
Purpose Used to delete a previously configured link aggregation group.
Syntax delete link_aggregation group_id <value 1-32>
Description This command is used to delete a previously configured link aggregation group.
Parameters <value 1-32> – Specifies the group ID.The Switch allows up to 32 link aggregation groups to be configured.The
group number identifies each of the groups.
Restrictions Only administrator-level users can issue this command.
Example usage:
To delete link aggregation group:
AT-9724TS:4# delete link_aggregation group_id 6
Command: delete link_aggregation group_id 6
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
config link_aggregation
Purpose Used to configure a previously created link aggregation group.
Syntax config link_aggregation group_id <value 1-32> {master_port <port> | ports <portlist> |
state [enable | disable]
Description This command allows you to configure a link aggregation group that was created with the create
link_aggregation command above.The AT-9724TS supports link aggregation cross box which specifies that
link aggregation groups may be spread over multiple switches in the Switching stack.
Parameters group_id <value 1-32> – Specifies the group ID.The Switch allows up to 32 link aggregation groups to be
configured.The group number identifies each of the groups.
master_port <port> – Master port ID. Specifies which port (by port number) of the link aggregation group will
be the master port.All of the ports in a link aggregation group will share the port configuration with the
master port.The port is specified by listing the switch number and the port number on that switch, separated
by a colon. For example, 1:3 specifies switch number 1, port 3. 2:4 specifies switch number 2, port 4.
ports <portlist> – Specifies a range of ports that will belong to the link aggregation group.The port list is
specified by listing the lowest switch number and the beginning port number on that switch, separated by a
colon.Then the highest switch number, and the highest port number of the range (also separated by a colon)
are specified.The beginning and end of the port list range are separated by a dash. For example, 1:3 specifies
switch number 1, port 3. 2:4 specifies switch number 2, port 4. 1:3-2:4 specifies all of the ports between switch
1, port 3 and switch 2, port 4 – in numerical order. Ports may be listed in only one port aggregation group, that
is, link aggregation groups may not overlap.
state [enable | disable] – Allows you to enable or disable the specified link aggregation group
Restrictions Only administrator-level users can issue this command. Link aggregation groups may not overlap.
Example usage:
To define a load-sharing group of ports, group-id 1,master port 5 of module 1 with group members ports 5-7 plus port 9:
AT-9724TS:4# config link_aggregation group_id 1 master_port
1:5 ports 1:5-1:7, 1:9
Command: config link_aggregation group_id 1 master_port
1:5 ports 1:5-1:7, 1:9
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
112
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual