Installation guide

31
Chapter 2
Installing the Hardware
This chapter contains an overview of the installation procedures for a stack
and the procedures for installing the hardware. The chapter contains the
following sections:
 “Installation Overview” on page 32
 “Reviewing the Safety Precautions” on page 34
 “Planning the Installation of a Stack” on page 36
 “Maximum Number of Switches in a Stack” on page 37
 “Unpacking a Switch” on page 38
 “Installing the AT-StackXG Stacking Module” on page 39
 “Installing the Power Cord Retaining Clip (AC Switches Only)” on
page 42
 “Disconnecting the Network Cables” on page 43
 “Installing the Switches in an Equipment Rack” on page 44
 “Labeling the Switches” on page 46