User`s guide

AT-9108, AT-8518, AT-8525, and AT-8550 User’s Guide
6-3
STPD Status for
GVRP-Added
Ports
If a port is added to a VLAN by GVRP, the newly added port reflects
the SPTD membership and status of the VLAN to which it is added.
For example, if VLAN
Red
is a member of STPD s0, and s0 is enabled,
then all ports added to VLAN
Red
by GVRP have s0 enabled on those
ports, as well. The command for disabling STP on a port basis
has
no
permanent affect on ports controlled by GVRP.
Note
For more information on GVRP, refer to Chapter 4.
Defaults
The default device configuration contains a single STPD called
s0
.
The default VLAN is a member of STPD s0.
All STP parameters default to the IEEE 802.1D values, as appropriate.