Installation guide

Factory Defaults
1-12
Factory Defaults
Table 1-5 shows factory defaults for the all switch models.
Table 1-5
Switch Factory Defaults
Item Default Setting
Port status Enabled on all ports
Serial or Telnet user
account
admin
with no password and
user
with no password
Console port configuration 9600 baud, eight data bits, one stop bit, no parity, XON/XOFF
flow control enabled
Web network management Enabled
SNMP read community
string
Public
SNMP write community
string
Private
RMON history session Enabled
RMON alarms Disabled
BootP Enabled on the default VLAN (
default
)
QoS All traffic is part of the default queue.
802.1p priority Recognition enabled
802.3x flow control Enabled
Virtual LANs One VLAN named
default
; all ports belong to the default VLAN.
The default VLAN belongs to the STPD named
s0.
802.1Q tagging All packets are untagged on the default VLAN (
default).
Spanning Tree Protocol Disabled; one STPD (
s0
)
IP Routing Disabled
Forwarding database aging
period
300 seconds (5 minutes)
RIP Disabled for the switch; enabled on each VLAN configured with
an IP address.
OSPF Disabled for the switch; enabled on each VLAN configured with
an IP address. All VLANs belong to the backbone area.
IP multicast routing Disabled
DVMRP Disabled for the switch; enabled on each VLAN configured with
an IP address.
IGMP snooping Disabled for the switch; enabled on each VLAN configured with
an IP address.
GVRP Disabled