Installation guide

AT-8350GB Installation Guide
61
3. Slide the GBIC module into one of the GBIC slots in the front of the
AT-8350GB switch. The GBIC module is completely seated in the slot
when it clicks into place.
Figure 34 Installing a GBIC Module
4. If you purchased two GBIC modules for the switch, repeat this
procedure to install the second module.
Note
In order to use a GBIC module in ports 49 or 50, you must configure
the port in the management software to operate as a GBIC port and
not as a twisted pair port. For instructions, refer to the AT-S41
Management Software User’s Guide for the AT-8350GB Switch.