Installation guide

Product Description
32
The AT-RPS2004 redundant power supply unit can support up to four
switches. This unit can be installed in a standard 19-inch equipment rack.
For instructions on how to install the unit, see Installing the AT-
RPS2004 Unit on page 74.
Figure 18 AT-RPS2004 Front & Back Panels
LEDs
The AT-RPS20004 power supply has LEDs on the left side of front panel
that display general status information. The system LEDs are defined in
Table 8.
Figure 19 AT-RPS2004 Power Supply LEDs
RPS4 RPS3 RPS2 RPS1
Front Panel
Back Panel
LEDs
RPS 14-pin Molex Connectors
AC power
connector
1 2 3 4 FANRPS
ACTIVE
ACTIVEACTIVE
FAILURE
STANDBY
FAILURE
RPS2004
1 2 3 4 FANRPS
ACTIVE
ACTIVEACTIVE
FAILURE
STANDBY
FAILURE
RPS2004
FAN LEDRPS LEDs