User`s guide

AT-S29 Management Software User’s Guide
83
SNMP Configuration
Use the SNMP Configuration screen to display and modify parameters
for the Simple Network Management Protocol (SNMP). The switch
includes an on-board SNMP agent which monitors the status of its
hardware, as well as the traffic passing through its ports. A computer
attached to the network, called a Network Management Station (NMS),
can be used to access this information. Access rights to the on-board
agent are controlled by community strings. To communicate with the
switch, the NMS must first submit a valid community string for
authentication. The options for configuring community strings and
related trap functions are described in the sections.
SNMP
Community
The following figure and table describe how to configure the
community strings authorized for trap management access. Up to 5
community names may be entered.
MAC
Address
- Physical address of the Agent Module
Number of
Telnet
Sessions
4 Sets the number of concurrent Telnet sessions allowed to
access the Agent Module.
Parameter Default Description
Parameter Description
Community String A community entry authorized for trap
management access. (The maximum string
length is 19 characters).
Access Mode Management access is restricted to Read Only or
Read/Write.
Add/Remove Add/remove strings from the active list
Community String:
Access Mode:
Read-Only
SNMP Community Capability: 5
Current:
New:
public RO
private RW
<<Add
Remove
netman RW