User`s guide

Using the System Configuration Program

You can use the Port Trunking Configuration screen to set up port trunks

as shown below:

Port Trunking Configuration

===========================

Trunk ID Status Member List

1 2 3 4

------- ------ ----------------------------------------

-- ----- Unit : - Unit : - Unit : - Unit : -

-- ----- Port : - Port : - Port : - Port : -

-- ----- Unit : - Unit : - Unit : - Unit : -

-- ----- Port : - Port : - Port : - Port : -

-- ----- Unit : - Unit : - Unit : - Unit : -

-- ----- Port : - Port : - Port : - Port : -

Trunk ID : 1 Trunk ID : 1 Member Unit : 1

Member Port : 1

[Show] [More] [Add] [Delete]

[Enable] [Disable]

<OK>

Use <TAB> or arrow keys to move, other keys to make changes.

Parameter Description

Trunk ID Configure up to four trunks per switch.

Unit Specifies a switch unit in the stack (1 to 4).

Port Select from 2 to 4 ports per trunk.

[Show] Displays trunk settings, where the first trunk listed is specified by “Trunk

ID.”

[More] Scrolls through the list of configured trunks.

[Enable] [Disable] Enables/disables the selected trunk.

[Add] [Delete] Adds/deletes the port specified by Trunk ID / Member Unit / Member Port.