User`s guide

AT-S29 Management Software User’s Guide
41
Configuring Port
Parameters
Use the Port Configuration menus to configure any port or module on
the switch.
Note
Auto-negotiation is not available for 100Base-FX ports.
Port Configuration: Unit 1 Port 1-12
=====================
Port Type Admin Flow Speed and
Control Duplex
-----------------------------------------------------
1 10/100TX ENABLED ENABLED 10-HALF
2 10/100TX ENABLED DISABLED 100-FULL
3 10/100TX ENABLED ENABLED AUTO
4 10/100TX ENABLED DISABLED AUTO
5 10/100TX ENABLED ENABLED 10-FULL
6 10/100TX ENABLED DISABLED 100-HALF
7 10/100TX ENABLED DISABLED AUTO
8 10/100TX ENABLED ENABLED AUTO
9 10/100TX ENABLED ENABLED AUTO
10 10/100TX ENABLED ENABLED AUTO
11 10/100TX ENABLED ENABLED AUTO
12 10/100TX ENABLED ENABLED AUTO
<APPLY> <OK> <CANCEL> <PREV Unit> <NEXT UNIT> <PREV
PAGE> <NEXT PAGE>
Use <TAB> or arrows keys to move. <Enter> to select.
<Space> to scroll options.
Parameter Default Description
Type Shows port type as:
10/100TX: 10Base-T/100Base-TX
100FX : 100Base-FX
1000SX : 1000Base-SX
1000LX : 1000Base-LX
Admin Enabled Allows you to disable a port due to abnormal behavior (e.g.,
excessive collisions), and then re-enable it after the problem has
been resolved. You may also disable a port for security reasons.
Flow Control Disabled Used to enable or disable flow control. Flow control can eliminate
frame loss by "blocking" traffic from end stations or segments
connected directly to the switch when its buffers fill. Back
pressure is used for half duplex and IEEE 802.3x for full duplex.
Note that flow control should not be used if a port is connected to
a hub.
Speed and
Duplex
Auto Used to set the current port speed, duplex mode, and auto-
negotiation.