User`s guide

AT-S39 Command Line Interface User’s Guide
91
ACTIVATE STP
Syntax
activate stp
Parameters
None
Description
Use this command to designate STP as the active spanning tree on the
switch. Once you have selected STP, you can enable or disable it using
the ENABLE STP and DISABLE STP commands. A spanning tree protocol
is active on a switch only if you designate it as the active spanning tree
and enable it.
Note
A change to the active spanning tree protocol with this command
will reboot the switch.
Example
The following command designates STP as the active spanning tree:
activate stp