User`s guide

AT-S39 Command Line Interface User’s Guide

SET SWITCH PORT

Syntax

set switch port=port|all

[status=forwarding|disabled]

[flowcontrol=none|transmit|recieve|both]

[bclimit=broadcastlimit]

[mdimode=mdi|mdix|auto]

[mirror=yes|no|all|none] [renegotiation=auto]

[softreset=yes|no]

[speed=autonegotiate|10mhalf|10mfull|10mhauto|

1000mfull|1000mfauto] [PVID=pvid]

[priority=priority] [overridepriority=yes|no]

Parameters

port Specifies the port you want to configure. You can

specify more than one port at a time. You can

specify the ports individually (e.g., 2,3,5), as a range

(e.g., 7-9), or both (e.g., 2,5,7-9). To specify all ports

on the switch, use ALL.

status Specifies the operating status of the port. Possible

settings are:

forwarding The port will accept and transmit

Ethernet frames. This is the default

setting for all ports on the switch.

disabled The port will not accept or transmit

frames.

flowcontrol Specifies the flow control on the port. Possible

values for this parameter are:

none No flow control.

transmit Flow control when transmitting

frames.

receive Flow control when receiving frames.

both Flow control when both transmitting

and receiving frames.

bclimit Specifies the maximum number of broadcast frames

the port will transmit during the interval specified by

the broadcast timer. The default is “0”, which

disables frame control on the port. For background