User`s guide

Chapter 17: TACACS+ and RADIUS Commands
148
SHOW AUTHENTICATION
Syntax
show authentication
Parameters
None.
Description
Use this command to display the following information about the
authenticated protocols on the switch:
The status of your authenticated protocol: enabled or disabled.
The authentication protocol activated on your switch. Either
TACACS+ or RADIUS protocols may be active. The TACACS+
protocol is the default.
The IP addresses of up to 3 authentication servers.
The encryption key for each individual server, if defined.
The global encryption code that applies to all authentication
servers.
The length of the time, in seconds, before the switch assumes the
server cannot respond.
Example
The following command displays authentication protocol information
on your switch:
show authentication