User`s guide
AT-S39 Command Line Interface User’s Guide
101
ACTIVATE RSTP
Syntax
activate rstp
Parameters
None
Description
Use this command to designate RSTP as the active spanning tree on the
switch. Once you have selected RSTP, you can enable or disable it using
the ENABLE RSTP and DISABLE RSTP commands. A spanning tree
protocol is active on a switch only if you designate it as the active
spanning tree and enable it.
Note
A change to the active spanning tree protocol with this command
will reboot the switch.
Example
The following command designates RSTP as the active spanning tree:
activate rstp