Installation guide

Installation
56
Installing the Switch in a Rack
Perform the following procedure to install the switch in a standard
19-inch rack. If you are not installing the switch in a rack, go to the next
procedure:
1. Place the unit upside down on a level, secure surface.
2. Using a flat-head screwdriver, remove the snap-on plastic feet from
the bottom of the switch, as shown in Figure 22.
Figure 22 Removing the Feet
3. Turn the switch over.
4. Attach a rackmounting bracket to one side of the switch using four of
the screws that came with the switch. See Figure 23.
Figure 23 Attaching Rackmounting Brackets