Instruction manual

Chassis Installation
14
4. Remove the four screws and rubber feet from the bottom of all modules as
shown in Part A of Figure 11.
Figure 11: Removing the Rubber Feet
5. Re-install the same four screws you removed in Step 4 without the rubber
feet, as shown in Part B of Figure 11.
Note
After removing the rubber feet, you must replace the screws. Otherwise,
the unit will expand and not fit in the chassis. Save the rubber feet so they
may be used again in a standalone configuration at a later date.
6. Remove the dust covers from the backs of all newly-shipped ATI modules,
as shown in Figure 12.
Figure 12: Removing the Dust Cover
AB
INTERREPEATER BUS
FIRMWARE CASSETTE
STATUS
POWER MASTER
FAULT
INTERREPEATER BUS
FIRMWARE CASSETTE
STATUS
POWER MASTER
FAULT
IEEE 802.3/ ETHERNET 10BASE2
8 PORT HUB/ REPEATER
with Network Management





Dust cover
Hub with dust cover installed
Interrepeater bus
port connector