Instruction manual

9
Chapter 2
Chassis Installation
This chapter describes the procedures to install a chassis in a rack or on a
desktop, and the procedures to install modules in the chassis.
Prerequisites to Install
You can install a variety of ATI products in the chassis; each one may have
specific features. Before proceeding, make sure you are familiar with:
❑ Your network’s configuration plan
❑ Cabling requirements of the modules you are installing
❑ Front panel indicators of the module’s normal operation
❑ A module’s error conditions and ways to respond to these conditions
Installation Sequence
Perform the installation procedures in the following sequence:
1. Voltage reconfiguration, if applicable, on page 10
2. Chassis installation (choose one that applies):
❑ Rack installation for rackmount chassis on page 12
❑ Horizontal mount installation for desktop chassis on page 12
❑ Vertical mount installation for desktop chassis (4-slot only) on page 12
3. Module installation beginning on page 13
4. Switch installation for a 7-slot segmented backplane configuration,
beginning on page 16
5. External switch installation beginning on page 17