Installation manual

AT-4016F Installation Manual

AT-4016F Ports

Station Ports There are 16 Fiber Optic station ports which can be used to connect to

workstations, servers or hubs.

RS232

Terminal Port

The AT-4016F includes an RS232 Terminal Port on the front panel. The

principal use for this port is the connection of a local network

management terminal to access ATI’s Omega agent.

PCMCIA

Interface

The PCMCIA Interface port, located on the front panel, is a read-only

interface that uses a standard 16-bit 2MB Flash EPROM PCMCIA card to

either restore software or to download updated software.

If a PCMCIA ﬁrmware card is installed before a reset or power-up

sequence, the AT-4016F boots from the PCMCIA card. Otherwise, it boots

from internal Flash RAM. For further details, see CentreCOM AT-4016TR

Operations Manual.

ATM Media

Interface

Located on the back panel, the ATM Media Interface can accommodate

multimode ﬁber, single mode ﬁber, or Level 5 UTP wire. An internal

96-pin DIN receptacle mates to the switch’s ATM Media Interface card.

Table 1 on page 2 lists the different types of media modules.

Figure 17 shows the factory-installed removable ATM Media Interface

that has been conﬁgured for a multimode ﬁber optic network. This

Interface can be used to connect to another AT-4016F, an ATM Switch, or

to an ATM adapter.

Figure 17: ATM Media

Interface