Installation manual
Overview
14
Configuration
Rules
Depending on the medium you choose, there are certain wiring practices
you must follow to ensure the reliability of communication throughout the
network. The AT-4016F complies with IEEE standards for 802.3 Carrier-
Sense Multiple-Access with Collision Detection (CSMA/CD) Ethernet and
with ATM Forum UNI Specification 3.0; you should refer to these
standards when implementing your network.
Power Supply The AT-4016F offers two redundant, removable, load-sharing power
supplies.
Table 3 shows the model numbers for the different power arrangements:
Table 3: AT-4016F Model Configuration
The first digit in the model name suffix indicates whether a power cord is
supplied. The second digit specifies a dual power-supply. The “x” in the
model name suffix indicates the factory-installed ATM Media Module.
For example, an AT-4016F-122 is a switch with a U.S.A.-style power cord,
dual power supply and, from Table 2, a 155 Mbps OC-3c/STM-1
multimode optical media module.
Network Management
All units come equipped with firmware-installed network management
agents. Additional information about AT-4016F network management can
be found under the separate document CentreCOM AT-4016TREthernet
Switch with ATM Access — Operations Manual which is shipped with each
system.
There are three types of network management:
❑ Omega local network management (ASYNC ASCII terminal port)
❑ Omega remote network management (Telnet session)
❑ SNMP
Upgrading
Software
The AT-4016F software is easy to upgrade through the PCMCIA memory
port. When you insert a PCMCIA Flash Memory Card into this port, the
new firmware is copied to the switch’s onboard non-volatile flash memory
at power-up. See the CentreCOM AT-4016TREthernet Switch with ATM
Access — Operations Manual for information on management software
capabilities and installation.
Further, an on-line Bulletin Board System (BBS) offers updated software
files that can be downloaded through either the TCP/IP applications
Trivial File Transfer Protocol (TFTP). This is discussed in the Preface of
this document.
AT-4016F Model Power Cord Power Supply
AT-4016F-12x US Style Power Cord Dual
AT-4016F-22x International (no cord supplied) Dual