Installation manual

Overview
2
Features
The following features are fully implemented
❑ “Hot swappable,” dual-redundant, load-sharing, modular power
supplies
❑ 16 Fiber Optic — either SC or ST connectors — ports
❑ ATM media interface, configurable by means of removable media
cards in several different media types
❑ RS232C ASYNC ASCII terminal port for local network
management
❑ Recessed reset switch
❑ Stand-alone or 19-inch rack mount chassis options
❑ Software upgradeability through a PCMCIA memory card
❑ Comprehensive diagnostic LEDs
❑ Separate Ethernet segment availability, with one or multiple DTEs
on all 16 switched ports
❑ Plug-in 155 Mbps Synchronous Optical Network (SONET) OC-3c
or SDH STM-1 ATM physical media modules that allow various
media choices:
— multimode fiber/SC connectors
— single mode fiber/SC connectors
— Level 5 UTP/100 Ω STP
❑ Signaling between AT-4016TR and ATM switches in conformance
with ATM Forum UNI 3.0 Specifications (Firmware dependent)
Note
Note that UNI 3.0 protocols cannot communicate with UNI 3.1 protocols
due to differences in signaling. Therefore, ensure that all your equipment
is at the same UNI standard.
Table 1 summarizes both versions of ATI’s Fiber Optic AT-4016F Switch.
Table 1: AT-4016F Multimode Fiber Options
Model Number Port Count Media/Connector Type
AT-4016F (ST) 16 Fiber Optic (FOIRL, 10Base-FL)
with Straight Tip (ST) connectors
AT-4016F (SC) 16 Fiber Optic (FOIRL, 10Base-FL)
with Subscriber Channel (SC) connectors