Specifications

AT-TS24TRS
38
As shown in the above figure, the AT-TS24TRS uses 24 RJ45 connectors
for UTP. Since the AT-TS24TRS model does not incorporate management
agent software, it can operate only as part of a non-managed hub or as a
Slave module in an ATI department concentrator chassis.
Features Table 6 summarizes the features of the AT-TS24TRS hub, including model
number, port count, and media/connector type for each Slave hub.
Table 6: AT-TS24TRS Features
The AT-TS24TRS is IEEE 802.3 compliant and Ethernet compatible.
When used in conjunction with an AT-TS00 Master in a department
concentrator chassis, the AT-TS24TRS supports ATI’s Omega Agent,
Simple Network Management Protocol (SNMP), the second version of the
Management Information Base (MIB-II) and Hub MIB.
For the AT-TS24TRS hub to be manageable, another hub must perform as
a Master in the chassis. TurboStack hub models that can function as a
Master are listed in Table 2 on page 5 of this manual.
Each manageable TurboStack hub is a single building block for both
standalone and chassis (department concentrator) configurations. ATI
supplies desktop and rackmount department concentrator chassis that
can hold up to eight TurboStack hubs.
Configurations The AT-TS24TRS is what is commonly called a Slave hub because it
depends on a Master hub for management, the AT-TS24TRS hub can
function in any of the following four configurations:
❑ As a standalone repeating device without management: A
standalone Slave hub performs simple regeneration and retiming
tasks in a variety of network configurations. This configuration can
use the hub’s AUI port to connect to a network backbone.
❑ As a hub module in a chassis: Up to 8 Slave modules can be
mounted in a single 8-slot chassis with standard backplane to act
collectively as a single logical hub without a Master.
❑ As a managed module in a department concentrator chassis with
standard backplane and a Master.
❑ As a managed module in a department concentrator chassis with
segmented backplane and a Master.
There are desktop and rackmount department concentrator chassis
available to hold from two to eight TurboStack hubs. Since the department
concentrator chassis connects hub modules across a backplane, a fully
populated department concentrator behaves as a single hub in the
network topology. This enables you to build and reconfigure networks
easily, efficiently and at minimum expense.
Model Number Port Count Media/Connector Type
AT-TS24TRS
24 RJ45 Connectors
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com