Specifications

TurboStack Series Hubs
17
4. Flip open (toward you) the two plastic doors on either side of the
repeater front panel, as shown in Figure 10.
5. Align the guide rails on either side of the module with the grooves in
the chassis slot, also shown in Figure 10. Then, slide the module into
the chassis without seating it in the backplane connector.
Note
The segmented backplane is designed with the bottom (slot 7) connector
offset from the other backplane connectors. This is done to accommodate
installation of the AT-TS90TR or AT-TS95TR switch module. If you use a
chassis with a segmented backplane, hubs may be installed only in slots 1
through 6, with slot 7 reserved for a switch module. If you use a chassis
with a standard backplane, hubs may be installed in any of the chassis
slots.
6. Plug in the module’s power cord.
Note
When inserting or removing repeater modules (using the hot swapping
method), you must be sure that the power cord is plugged in. To enable hot
swapping, you must disconnect the module from the backplane before you
unplug the power cord.
7. Check to see that the Power indicator illuminates.
Figure 10: Installing a Module
in a Chassis
Chassis frame
Generic
Module
Plastic
Module
screws
Slave hub
guiderail
door/handle
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com