Specifications

Hardware Installation
16
1. Every ATI hub is shipped with a dust cover on the interrepeater bus
port, located on the back of the module, to prevent static discharge and/
or damage to the connector pins. Before the module is installed in a
multi-module chassis, the dust cover must be removed, as shown in
Figure 7.
2. Remove the rubber feet from the module (see Figure 8).
3. Be sure to reinstall the screws after removing the rubber feet to
prevent the module casing from expanding and warping (see Figure 9).
Figure 7: Removing
Interrepeater Bus
Dust Cover
Figure 8: Removing Rubber
Feet from Module
Figure 9: Reinstalling Screws
POWER MASTER FAULT
POWER MASTER FAULT
IEEE 802.3/ ETHERNET 10BASE 2
8 PORT HUB/ REPEATER
w
ith Network Management
Hub with dust cover installed
Hub with dust cover removed
Interrepeater
bus port
connector
Dust
cover
Rubber foot
(1 of 4) in
bottom of
module
Reinstall
all 4 screws
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com