Installation manual

Configure drivers

Configuring the AT-2560TX 10/100 PCI for full-duplex. If you have a

switch that doesn’t support auto-negotiation, you’ll need to

manually configure for speed and full-duplex support.

Configuration is specific to the driver you’re loading for your

network environment. See the table below.

NOTE

On a AT-2560TX 10/100 PCI, you must set the Speed when

configuring for full-duplex support. Don’t leave the Speed set

to Auto-negotiate.

Others network software See the Duplex support README file.

To view the README files, insert the

Allied Telesyn CardAssistant diskette,

and from the DOS-prompt type

SETUP /README

Table 5: Steps for Setting AT-2560TX 10/100 PCI Duplex Mode

If you’re using this driver. . . set the duplex mode by. . .

DOS/ODI clients Editing the NET.CFG file. Add these

parameters under the Link Driver

section:

SPEED 100 (or 10 for AT-2560TX 10/

100 PCI 10 Mbps operation)

FORCEDUPLEX 2

Table 4: Steps for Setting AT-2560FX 100 PCI

Duplex Mode (Continued)

If you’re using this driver . set the duplex mode by. . .

ENTER