Installation manual

AT-2560FX 100 and AT-2560TX 10/100 PCI

❑ LANtastic

❑ Banyan

Set speed (AT-2560TX 10/100 PCI option)

The AT-2560TX 10/100 PCI default is to auto-set the card for the

network speed. Configuration for manually fixed speed is an

option; you must set the speed manually when configuring the

AT-2560TX 10/100 PCI for full-duplex support. The steps for

setting speed are specific to the driver you’re loading for your

network environment. See Table 3.

Table 3: Steps for Setting AT-2560TX 10/100 PCI Speed

If you’re using this driver. . . set the speed by. . .

DOS/ODI clients Editing the NET.CFG file. Add this

parameter under the Link Driver section:

SPEED 100 (or 10 for 10 Mbps

operation)

Windows NT Using the A2560SET program:

1. Click “Network” in the Control Panel.

2. Click the Configure button. The

A2560SET program runs.

3. Click the Change button. Set Speed to

100 (or 10), exit A2560SET and restart

Windows.

Windows 95 Setting the Speed in the Control Panel:

1. Click the Network icon in the Control

Panel and select the Configuration tab.

2. Select the Allied Telesyn AT-2560TX

10/100 PCI.

3. Click the Properties button and select

the Advanced tab.

4. Set Speed to 100 Mbps (or 10 for 10

Mbps operation), exit A2560SET and

restart Windows.