Installation manual

Configure drivers

❑ Make sure adapter and hub duplex mode match. See page 17

for more information on duplex modes for the AT-2560FX

100 and AT-2560TX 10/100 PCI adapters.

❑ (AT-2560TX 10/100 PCI only) Make sure you’re using

Category 5 wiring when operating at 100 Mbps.

❑ Make sure the network cables are securely attached to both

the adapter and hub port and the card is communicating:

For the AT-2560FX 100 PCI, check that the receive light is

flashing. For the AT-2560TX 10/100 PCI verify that the

adapter LNK light is on.

❑ At 100 Mbps, make sure you are connected to a 100BASE-

TX hub (not a 100BASE-T4).

❑ Test the adapter (see page 13).

❑ Check the help (see page iv for instructions).

Other Operating Systems and Servers

If you’re using an operating system (OS) other than DOS,

Windows 3.1, Windows NT, or Windows 95, or if you are setting

up a server, you’ll need to read our online tips.

On a DOS computer, view the appropriate help file for

information on installing your network driver.

To view help, insert the Allied Telesyn CardAssistant disk into a

drive, switch to that drive, and type

SETUP /README

Look through the first selection, which covers installing ATI AT-

2560FX 100 and AT-2560TX 10/100 PCI Ethernet Adapter

drivers, for the operating system you need. The README files

contain driver information for the following:

❑ Novell (client & server)

❑ IBM

❑ Microsoft (workstation & server)