Installation manual

AT-2560FX 100 and AT-2560TX 10/100 PCI

5. When SETUP finishes the tests, the Install network

drivers screen appears.

6. Select the driver you want to install.

SETUP can install a NetWare client driver for you. If

you’re installing other drivers, SETUP displays a

README file with installation instructions.

Test the adapter with a responder on the network (optional).

SETUP can test the network more thoroughly if you have a

responder on the network while running the tests.

1. Go to a computer on the network with an AT-2560FX 100

PCI or AT-2560TX 10/100 PCI installed.

2. Run the SETUP program, and set up the adapter as a

responder.

3. Return to the computer you want to test. Run SETUP and

test the adapter.

Troubleshooting. If you can’t connect to a server, try the

suggestions here, then turn to page 21 for the AT-2560FX 100

PCI or page 23 for the AT-2560TX 10/100 PCI.

❑ Make sure you’re using the drivers for this adapter.

❑ If you’re replacing an existing adapter, make sure the

LINK statement in your

NET.CFG is correct for your new

adapter. For example, the LINK statement for a NetWare

client should be:

LINK DRIVER A2560ODI

❑ Verify FRAME type in your NET.CFG file matches frame

type your server is using.

❑ If setting up a server, check your LOAD and BIND

statements. (For NetWare, type config at the console to

make sure the driver is loaded and protocols are bound to

the driver.)

❑ Make sure the PCI slots are busmaster enabled (refer to

your computer’s documentation).