Installation manual

AT-2560FX 100 and AT-2560TX 10/100 PCI

If you’re testing an existing AT-2560TX 10/100 PCI adapt-

er, the network driver will probably be active and the diag-

nostics will test the driver. This diagnostic tracks the driv-

er’s actual network activity.

2. Click OK to accept the adapter’s configuration.

3. Click OK in the Network Settings dialog box and when

prompted, restart Windows NT.

4. To install multiple adapters, repeat this procedure for each

new adapter. See “Install multiple adapters” on page 17.

To run the A2560SET software at any time, double-click the

Allied Telesyn AT-2560TX 10/100 PCI icon in the Control Panel.

Troubleshooting.

If you can’t connect to a server, or if Windows

NT reports an error while trying to connect, try the suggestions

here, then turn to page 21 for the AT-2560FX 100 PCI or page 23

for the AT-2560TX 10/100 PCI.

❑

Make sure you’re using the drivers that are on the

CardAssistant diskette that ships with this adapter.

❑

Make sure the driver is loaded and the protocols are bound.

See the Network Bindings dialog box in Windows NT.

❑

Make sure the PCI slots are busmaster enabled (refer to

your computer’s documentation).

❑

Make sure network cables are securely attached to both the

adapter and hub port and the adapter LNK light is on.

❑

Make sure the hub port is configured for the same duplex

mode as the adapter. See page 17 for more information on

full duplex.

❑

Test the adapter (page 10).

❑

After installing the adapter you can run A2560SET from

your hard disk. To do this, double-click the A2560SET icon

in the Control Panel.

❑

Check with your LAN administrator—you may need to

install supplemental networking software.