Installation manual

AT-2560FX 100 and AT-2560TX 10/100 PCI
10
Manually adding an adapter in Windows 95. If the New Hardware
Found dialog box does not appear at startup, or if you are adding
a second adapter, use the following procedure.
1. From the Control Panel, double click the System icon.
2. Click the Device Manager tab in the window that appears.
3. Double-click Other Devices (question mark icon) in the list.
4. Double-click PCI Ethernet Controller.
5. Click the Driver tab and then click Change Driver.
6. Select Network Adapters and click OK.
7. Click Have Disk from the window that appears. Insert the
Allied Telesyn CardAssistant disk and click OK.
8. Follow any prompts for Windows 95 installation disks and
restart when prompted.
Troubleshooting. If you can’t connect to a server or Windows 95
reports an error after you double-click Network Neighborhood,
see page 21 for the AT-2560FX 100 PCI or page 23 for the AT-
2560TX 10/100 PCI.
Windows NT—server or workstation
If your computer displays an error while booting, it may require
additional steps to configure. See the PCI Installation Tips
section on page 26 for more information if you get an error.
NT 4.0—install network drivers. After putting the adapter in the
computer and starting Windows NT, you need to install the
drivers and test the adapter.
1. Double-click the Network icon in the Control Panel.
2. Select the Adapters tab; click the Add button.
3. From the Select Network Adapter pop-up window, do not
select from the Network Adapter list; choose the Have
Disk button.