Installation manual

Configure drivers

1. Insert the CardAssistant disk.

2. From Explorer, double click on the 3.5 Floppy disk icon.

3. Find the A2560SET icon and click the right mouse button.

From the menu that appears click Install.

4. The A2560SET files are copied to your hard disk.

5. Start A2560SET by double-clicking on its icon in the

Control Panel. (If the icon doesn’t show up, choose Refresh

under the View menu in the Control Panel window.)

6. The A2560SET software examines your computer and

displays the Adapter Setup Window. This window shows

the adapter’s I/O address, interrupt, and Ethernet address.

7. Click Test to begin diagnostics.

There are two testing options. Testing with the NDIS driver

checks overall operation of the adapter with the network. The

second option tests the adapter hardware only. Read both

sections below before testing.

Test the adapter and driver together.

The adapter and driver test

doesn’t require you to unload the NDIS driver. You don’t need to

restart after testing.

1. Click Test NDIS.

2. When the test is complete, click OK to exit.

3. If this test fails, try again, unloading NDIS first.

Test the adapter hardware only (recommended).

This test unloads

the NDIS driver. You will need to restart after testing.

1. Click Unload NDIS.

2. After the NDIS driver unloads, click OK to continue.

3. When the test is complete, click OK to exit or click

Advanced for more testing options. Click Help in the

Advanced Diagnostics window for more information.

4. Restart the computer. You must restart the computer

before accessing any network drives.