Installation manual

AT-2560FX 100 and AT-2560TX 10/100 PCI

Some networking software does not provide an install program

for the driver. In this case, the manufacturer’s instructions for

installing the software is your primary source of information.

There are some installation notes beginning on page 15; the

README files on the CardAssistant diskette may also help.

Windows 95

Have your Windows 95 installation media available, as Windows

95 prompts for files when you install the new adapter.

NOTE

Windows 95 attempts to find the auxiliary files it needs, and

gives a message if a file is not found. In this case, either the

diskette drive or CD-ROM drive designation are needed as the

path. If you installed Windows 95 from CD-ROM, the

installation files are typically located at

D:\win95

, where

is your CD-ROM drive.

1. After you install the AT-2560 adapter, start Windows 95.

The New Hardware Found dialog box appears. If this box

does not appear and Windows 95 starts normally, you will

need to manually add the adapter software. See page 10.

2. Click “Driver from disk provided by hardware

manufacturer,” then click OK. The Install From Disk dialog

box appears.

3. Insert the Allied Telesyn CardAssistant disk.

4. Specify A:\ (or B:\) as the path, then click OK.

5. Follow prompts for any Windows 95 installation disks and

restart when prompted.

Install A2560SET software and test the adapter.

Although not

required for operation, it’s a good idea to run diagnostic tests

every time you install an adapter. The Allied Telesyn A2560SET

program is an enhanced configuration and diagnostics utility for

Windows 95. To install A2560SET: