Specifications

6 AR400 Series Router
C613-03086-00 REV A
• AT-AR026 4ETH PIC, four 10BASE-T/100 BASE-TX auto-negotiating
ports with RJ-45 connectors.
• AT-AR027 VoIP-FXS PIC, two Foreign Exchange Subscriber (FXS) ports
with RJ-11 connectors.
When installed in an AR410 or AR410S router and operating in V.35 mode,
synchronous PICs have full V.35 functionality, but their output voltages may
not be within the voltage range set by the V.35 specification.
Synchronous PICs installed in an AR410 or AR410S cannot be fully tested with
Syntester.
The MAC slot can accommodate any one of the following MACs:
• AT-AR010 EMAC, Encryption MAC.
• AT-AR011 ECMAC, Compression/Encryption MAC
• AT-AR011 V2 ECMAC, Compression/Encryption MAC (factory fitted
in the AR410S router).
• AT-AR012 CMAC, Compression MAC.
MACs should be installed by authorised service personnel only. Unauthorised
opening of the router lid may cause danger of injury from electric shock, damage
to the router, and invalidation of the product warranty.
Front and rear panels of the AT-AR410 router with a PIC installed are shown in
the following figure. Apart from a different model name, the AR410S is
externally identical to the AR410.
Figure 1-1: Front and rear panels of the AT-AR410 Series router.
POWER
SYN
Tx
Rx
AC Power Switch
AC Power Inlet Console Port10/100 Switch Ports
PIC Bay (with optional
AT-AR023 SYN PIC)
CONSOLE RS-232
PIC BAY0
3X
ASYN0
2X 1X
4
POWER
10BASE-T/100BASE-TX SWITCH PORTS
X PC
= HUB
ETH0
ETH 0
AR410
Branch Office Router
POWER SYSTEM
STATUS
ENABLED
1234
LINK/ACT
FULL DUP
100M
LINK/ACT
FULL DUP
100M
10BASE-T/100BASE
-
TX SWITCH PORTS
ETH0PIC BAY0