Install guide

Quick Install Guide 7
C613-04032-01 REV C
LEDs and What They Mean
LEDs indicate the router’s operational status and port activity. Descriptions of
PIC LEDs can be found in the PIC Quick Install Guide and the PIC Hardware
Reference.
Troubleshooting Installation
If you have problems installing the router, try one or more of the following:
No LEDs Light
The most likely reason is that the router is not receiving power. Check the
following:
1. Check that the supply outlet’s switch is in the ON position.
2. Test the mains power outlet to verify that it is working.
If the problem persists, please contact your authorised Allied Telesyn
distributor or reseller.
AR410 System LEDs
LED State Function
Power Green The router is receiving power and the power
switch is in the ON position
System Amber The router is malfunctioning
Off Normal operation
Enabled
(PIC Bay 0)
Green A PIC card is correctly installed and has been
detected by the router
Off No PIC is installed
Full Dup
Green The corresponding port is operating at full-
duplex
Off The corresponding port is operating at half-
duplex
Link/ACT
Green A link has been established through the
corresponding port
Flashing Data is being transmitted through the
corresponding port
Off No link is present through the corresponding
port
100M
Green The corresponding port is operating at
100Mbps
Off The corresponding port is operating at 10Mbps