User guide

Table Of Contents
Configuring for the First Time 5-21
Note for Australia only: To make this call semi-permanent, you will need to do
three things. Firstly, select Make call semi-permanent in this page. Secondly, set
the Auto-disconnect time to Off after you have finished the Configuration Wiz-
ard (see the Inter-Office Connection page (Figure 7-6)). Thirdly, tell the net-
work administrator at your remote office that you have set up a semi-permanent
call with lower ISDN call charges, so that the router at the remote office can be
configured only to accept incoming calls from your office, and not to send out-
going calls to your office, since the latter would be charged at a higher casual
rate.
Caution for Australia only: If you subscribe to OnRamp Express, outgoing
calls will be charged at a lower rate than the casual ISDN call charge. Calls
from a subscriber that does not have OnRamp Express to a subscriber that
does have OnRamp Express will be charged at the higher casual rate, even if
the call is made semi-permanent. This could lead to high ISDN call charges.
If unsure, check with your ISDN service provider.
Note: If you have an AR140 with voice ports, and want to use telephones or
other devices connected to these, do not make calls to both the Internet and your
remote office semi-permanent. If you do, there will be no channels available for
phone calls.
Click Next.