User guide

Configuring for the First Time 5-13
call with lower ISDN call charges, so that the router at the remote office can be
configured only to accept incoming calls from your office, and not to send out-
going calls to your office, since the latter would be charged at a higher casual
rate.
Caution for Australia only: If you subscribe to OnRamp Express, outgoing
calls will be charged at a lower rate than the casual ISDN call charge. Calls
from a subscriber that does not have OnRamp Express to a subscriber that
does have OnRamp Express will be charged at the higher casual rate, even if
the call is made semi-permanent. This could lead to high ISDN call charges.
If unsure, check with your ISDN service provider.
■
Click Next.
6. The Configuration Summary page for an inter-office connection (Figure
5-10) shows a summary of all the router configuration parameters you have
entered, as well as standard parameters in the configuration.
Figure 5-10: Configuration Summary page for an inter-office connection
The wizard creates a standard configuration using the parameters you have
entered. You can change these and other parameters from the Main Menu
page in the future if you wish.
■
If you wish to change any of the parameters you have entered, use the
Back button at the bottom of the page to go back to the page you want
to change.
■
If you are satisfied with the configuration and want to test your Internet
connection, click Test Connection. The Test Results page (Figure 5-6)
opens to show you a summary of the connection test results.
■
When you are satisfied with the configuration, click End Wizard to save
the configuration. The AR100 Main Menu page (Figure 4-2) opens.