User guide
Table Of Contents
- Title Page
- About
- Contents
- Introduction
- Installing the AR100 Series Internet Router
- Getting Connected
- About Web Access to the AR100
- Configuring for the First Time
- Configuring for a Leased Line
- Changing Your Configuration
- Using Telephony Services
- Accessing Router Utilities
- Troubleshooting
- Safety and Statutory Information
4-4 Navigating the configuration pages
■
If you haven’t yet changed the initial manager password, we recom-
mend that you do this now, by following the instructions in “Changing
system information” on page 7-2.
■
To use the other router utilities available from the Main Menu, see Chap-
ter 9, Accessing Router Utilities.
■
If you have an Internet connection, you can go to the Allied Telesyn
International support page by clicking ATI Online.
Navigating the configuration pages
While using the AR100 Configuration and Management Wizards, use the but-
tons on the pages to navigate, not the browser’s Back and Forward buttons, to
ensure that configuration information is stored correctly.
Saving and exiting the web pages
The AR100 Configuration Wizard saves the configuration you enter when you
click End Wizard on the Configuration Summary page. If you leave the Config-
uration Wizard before clicking End Wizard, no configuration data is saved,
and you will have to run the Wizard again from the beginning.
The AR100 Management Wizard saves any configuration changes you make
when you click OK in the page where the changes are made.
To leave either the Configuration or Management Wizards, simply close the
web browser, or use it to go to another web address outside of the router’s
pages.