User guide
Table Of Contents
- Title Page
- About
- Contents
- Introduction
- Installing the AR100 Series Internet Router
- Getting Connected
- About Web Access to the AR100
- Configuring for the First Time
- Configuring for a Leased Line
- Changing Your Configuration
- Using Telephony Services
- Accessing Router Utilities
- Troubleshooting
- Safety and Statutory Information
4-2 One at a time
One at a time
Only one user at a time can access the AR100 Configuration Wizard to config-
ure the router. If you leave the wizard for more than thirty minutes while you
are in the middle of configuring it, another user can log into it. This will restart
the configuration wizard without permanently saving any of the configuration.
The second user can then configure the router from the beginning.
More than one person can access the AR100 Management Wizard Main Menu
and Monitoring pages of a configured router at the same time, since these
pages are not used to change the router’s configuration. If you leave the other
AR100 Management Wizard pages for more than thirty minutes, a second user
can access the pages. If they do, then you (the first user) will lose access to the
Management Wizard pages. Otherwise you will get another thirty minutes
exclusive access to the Management Wizard pages as soon as you start using
them again.
Security
When you have completed the Configuration Wizard and arrive at the Main
Menu page, we recommend that you change the management password. This
is the password you use to log in to the router. It is very important that you
remember this password, as it is encrypted, and there is no way to retrieve it
from the router.
Note that the other passwords entered on the Configuration Wizard pages for
connecting to your ISP or remote office can be seen by anyone backing through
the web browser pages on the PC.
Access the router with your web browser
1. Insert the Installer and Documentation CD-ROM in the CD ROM drive. The
CD-ROM Main Menu screen (Figure 3-8) is displayed. Click Configure
Router. The Welcome to the AR100 Access Wizard dialog (Figure 3-10)
opens. Click Start. The Select a Router dialog (Figure 3-11) opens.
2. Select the router you want access to, and click Next.
If you select an uninitialised router, the AR100 Access Wizard leads you
through the configuration process. See “Getting the PC and router communi-
cating” on page 3-8.
If you select an initialised router, your web browser is connected to the rout-
er, and the Enter Network Password dialog (Figure 4-1) opens.