User guide

Safety and Statutory Information 11-3
A label is located on the underside of the base unit containing the FCC registra-
tion number. You must, upon request, provide the following information to
your local telephone company:
Facility Interface Code 02IS5
Service Order Code 6.0Y
The AR130 and AR140 have completed the ISDN Ordering Codes
Translation Review and are registered for IOC S and EZ-ISDN 1.
USOC Jack Type RJ49C
Should you experience trouble with this telephone equipment, please contact:
ALLIED TELESYN INTERNATIONAL
19800 NORTH CREEK PARKWAY #200
BOTHELL
WASHINGTON 98011
TEL: [phone]
FAX: [phone]
If trouble is experienced with this equipment (AR140U OR AR130U), for repair
or warranty information, please contact the above. If the equipment is causing
harm to the telephone network, the telephone company may request that you
disconnect the equipment until the problem is resolved.
This equipment cannot be used on public coin phone service provided by the
telephone company. Connection to party line service is subject to state tariffs.
Your telephone company may discontinue your service if your equipment
causes harm to the telephone network. They will notify you in advance of
disconnection, if possible. During notification, you will be informed of your
right to file a complaint to the FCC.
Occasionally, your telephone company may make changes in its facilities,
equipment, operation, or procedures that could affect the operation of your
equipment. If so, you will be given advance notice of the change to give you an
opportunity to maintain uninterrupted service.
For repair/warranty information. The telephone company may ask you to
disconnect this equipment from the line network until the problem has been
been corrected.
9. Canadian Department of Communications
NOTCE: The Industry Canada label identifies certified equipment. This
certification means that the equipment meets telecommunications network
protective, operational and safety requirements as prescribed in the
appropriate Terminal Equipment Technical Requirements document(s). The
Department does not guarantee the equipment will operate to the user's
satisfaction.
Before installing this equipment, users should ensure that it is permissible to be
connected to the facilities of the local telecommunications company. The
equipment must also be installed using an acceptable method of connection.
The customer should be aware that compliance with the above conditions may
not prevent degradation of service in some situations.
Repairs to certified equipment should be coordinated by a representative
designated by the supplier. Any repairs or alterations made by the user to this
equipment, or equipment malfunctions, may give the telecommunications
company cause to request the user to disconnect the equipment.
Users should ensure for their own protection that the electrical ground
connections of the power utility, telephone lines and internal metallic water