User guide
Table Of Contents
- Title Page
- About
- Contents
- Introduction
- Installing the AR100 Series Internet Router
- Getting Connected
- About Web Access to the AR100
- Configuring for the First Time
- Configuring for a Leased Line
- Changing Your Configuration
- Using Telephony Services
- Accessing Router Utilities
- Troubleshooting
- Safety and Statutory Information
11-2 Safety and statutory statements
The following interfaces are Telecommunications Network Voltage (TNV1) cir-
cuits which operate normally within the limits of SELV:
■
BRI ports for connection to ISDN Basic Rate telecommunications networks.
Note: A TNV1 circuit is a circuit which under normal operating conditions does
not exceed the limits for SELV but on which overvoltages from
TELECOMMUNICATION NETWORKS are possible.
The following interfaces are Telecommunications Network Voltage (TNV2) cir-
cuits:
■
POTS ports (AR140 only).
Note: A TNV2 circuit is a circuit which under normal operating conditions may
exceed SELV but on which overvoltages from TELECOMMUNICATION
NETWORKS are not possible.
5. Product servicing
This product contains no user-serviceable parts. All product servicing must be
carried out by qualified service personnel.
6. Lithium cell
This product includes an Integrated Circuit containing a Lithium cell. It carries
a warning
Do not dispose in fire
This warning should be strictly adhered to. Replacement and disposal of this
device must be carried out by qualified service personnel.
Warning: Danger of explosion if the battery is incorrectly replaced. Replace
only with the same type or equivalent type recommended by the
manufacturer. Dispose of used battery according to the manufacturer’s
instructions.
7. European EMC compliance
This product meets the requirements of the European Electromagnetic
Compatibility (EMC) Directive 89/336/EEC. The product complies with the
requirements of CISPR 22 (EN55022) for Emissions and EN50082-1 for
Immunity for limits of radio disturbance characteristics for Information
Technology Equipment (ITE).
8. US Federal Communications Commission (FCC)
This equipment complies with Part 15 of FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
This equipment complies with Part 68 of the Federal Communications Com-
mission (FCC) rules for the United States.