User guide
Table Of Contents
- Title Page
- About
- Contents
- Introduction
- Installing the AR100 Series Internet Router
- Getting Connected
- About Web Access to the AR100
- Configuring for the First Time
- Configuring for a Leased Line
- Changing Your Configuration
- Using Telephony Services
- Accessing Router Utilities
- Troubleshooting
- Safety and Statutory Information
10-8 Communication problems between PC and router
Not responding
If this dialog appears, the uninitialised router is not responding as expected to
the AR100 Access Wizard.
Figure 10-7: Not Responding dialog
■
Make sure that the router is connected to the power supply.
■
Make sure the Ethernet port on the PC is connected to one of the LAN
ports on the router by an Ethernet direct cable. If connected to LAN port 4,
make sure that the PC/Hub switch is in the PC position. Click Continue.
■
If the problem persists, contact your authorised Allied Telesyn distributor
or reseller.
No free IP address
Your router needs an IP address. This dialog appears if there are no IP
addresses available.
Figure 10-8: No Free IP Address dialog