User guide
Table Of Contents
- Title Page
- About
- Contents
- Introduction
- Installing the AR100 Series Internet Router
- Getting Connected
- About Web Access to the AR100
- Configuring for the First Time
- Configuring for a Leased Line
- Changing Your Configuration
- Using Telephony Services
- Accessing Router Utilities
- Troubleshooting
- Safety and Statutory Information
Troubleshooting 10-5
TCP/IP not installed
TCP/IP is the protocol that the PC uses to communicate with the router. If this
dialog appears, you will need to install and configure TCP/IP on your PC.
Figure 10-3: TCP/IP Not Installed dialog
Follow the instructions in “Installing TCP/IP on your PC” on page 3-1, or in the
Start Here Guide.
Wizard already active
If you already have the AR100 Access Wizard running on your PC and try to
start another one, this dialog appears.
Figure 10-4: Wizard Already Active dialog
■
Exit this AR100 Access Wizard, and use the one that was already running.