User guide
Table Of Contents
- Title Page
- About
- Contents
- Introduction
- Installing the AR100 Series Internet Router
- Getting Connected
- About Web Access to the AR100
- Configuring for the First Time
- Configuring for a Leased Line
- Changing Your Configuration
- Using Telephony Services
- Accessing Router Utilities
- Troubleshooting
- Safety and Statutory Information
Changing Your Configuration 7-15
to change its configuration. Should this happen, the only way for the PC to
get access to the router’s configuration is to change its own Ethernet IP
address so that it is in the same IP subnetwork as the router, and then reboot.
■
To change the configuration of the router’s Ethernet LAN connection, click
on the Ethernet LAN Connection/Modify button in the Update
Configuration page (Figure 7-2).
The Ethernet LAN Connection page (Figure 7-7) opens, showing the rout-
er’s Ethernet IP address and mask and whether or not the router’s DHCP
server is enabled.
Figure 7-7: Ethernet LAN Connection page
■
If necessary, enable or disable the router’s DHCP server
■
If necessary, change the router’s Ethernet IP address or mask.
■
To return to the Update Configuration page (Figure 7-2) without saving
any changes to the inter-office connection configuration, click Cancel.
■
To save the changes click OK. If you change the IP address, the browser
will no longer be connected to the router. You can either enter the new IP
address in the browser’s address field, or close your browser and find the
router again with the AR100 Access Wizard.