User guide

2-12 AR100 Series Internet Router User Guide
Connect your router
1. Switch off the power to your computer.
2. Connect the ISDN port on the router to the ISDN line wall jack or NT1,
using the supplied green ISDN cable.
3. Connect one of the hub ports on the AR100 to the Ethernet adapter card on
your PC using a CAT 5 cable (obtained from your PC supplier).
4. If you have an AR140 with voice ports, connect up to two telephones,
facsimile machines, or answer phones to the voice ports.
5. Connect the router to the mains power supply using the power supply unit
supplied. Switch on the mains power supply. The front panel LEDs will
light. Wait for about two minutes for the router to complete its startup
sequence and self-tests.
Note: If the mains supply is outside the accepted range for the router,100–240 VAC and
50–60 Hz, the router will not operate and may be damaged.
6. Switch on your. The router is now ready for initialisation. Proceed to
Chapter
3, Getting Connected
.