User guide

Log and Trap Listing by Reason Code Overview
4-59
Log Reference for SBx3100 and iMAP Series Switches (iMAP Logs with Traps)
1. Set the loopback configuration back to "NONE" and try again.
Alarms The following components are affected:
Component Status Alarm
• DS1 Port Failed Major
• E1 Port Failed Major
2.29.9 Timing Reference Failed
Message Port Fault Set
Severity Minor
Explanation Not supported in R5.0. [Still True?] [To Be Supplied]
Action Perform the following:
1. To B e S u p p l i e d
Alarms The following components are affected:
Component Status Alarm
• DS1 Port Failed Major
• E1 Port Failed Major
2.29.10 Link Quality Failed
Message Port Fault Set
Severity Major
Explanation Some services that are carried across an MLPPP interface are espe-
cially sensitive to packet loss, thus action must be taken to move
traffic off of a physical interface without waiting for it’s
defects to soak into faults (typically 2.5 seconds). It is possible
for transient failures to cause the physical interface to be
removed from service while the “normal” alarms (e.g. LOS, LOF) are
never completely soaked, so this specialized alarm is raised on the
physical interface to immediately indicate to the user that it has
been removed from service.
Action Perform the following:
1. To B e S u p p l i e d
Alarms The following components are affected:
Component Status Alarm
• DS1 Port Failed Major
• E1 Port Failed Major