User guide

Overview Log and Trap Listing by Reason Code
Log Reference for SBx3100 and iMAP Series Switches (iMAP Logs with Traps)
4-10
Explanation The interface is carrying a signal, but the ADSL card is unable to
frame against the signal. As a result, all packets are being
tossed.
Action Perform the following:
1. Verify that the provisioning characteristics of the ADSL port match those of the device
to which it is attached.
2. If there are any differences, correct them.
3. If there are no differences, attempt disabling and then re-enabling the port to see if the
problem persists.
Alarms The following components are affected:
Component Status Alarm
• None
2.2 ADSL022 - adslAturPerfLossThreshTrap
2.2.1 Not Applicable
Message Atur (Far End) Loss of Signal TCA on port
Severity Minor
Explanation The interface is no longer receiving a signal from far-end equip-
ment. The number of seconds the LOS defect has existed exceeds the
provisioned threshold for the current 15-minute period.
Action Perform the following:
1. Check the far-end equipment to make sure that it is still in-service.
Alarms The following components are affected:
Component Status Alarm
• None
2.3 ADSL024 - adslAtucPerfLprsThreshTrap
2.3.1 Not Applicable
Message Atuc (Near End) Loss of Power TCA on port
Severity Minor
Explanation Normally means the far end equipment has been powered-down. The
number of seconds the LPR defect has existed exceeds the provi-
sioned threshold for the current 15-minute period.
Action Perform the following: