UPLINK MODULE QUICK INSTALL GUIDE S i m p ly c o n n e c t i n g t h e wo r l d
Uplink Module Quick Install Guide Document Number C613-04022-01 REV D. Copyright © 1999-2001 Allied Telesyn International, Corp. 960 Stewart Drive Suite B, Sunnyvale CA 94086, USA. All rights reserved. No part of this publication may be reproduced without prior written permission from Allied Telesyn. Allied Telesyn International, Corp. reserves the right to make changes in specifications and other information contained in this document without prior written notice.
Quick Install Guide 3 Models Covered By This Guide This Quick Install Guide includes information on the following models: ■ AT-A35/SX ■ AT-A35/LX ■ AT-A39/T The latest Quick Install Guide can be found at www.alliedtelesyn.co.nz/ support/support.html. Compatible Switch Units Uplink Modules can be used with all Rapier Switches and all AR800 Modular Switching Routers. Package Contents The following items are included with each Uplink Module.
Uplink Module 2. Gather the tools and equipment you will need. A medium-sized flat-bladed screwdriver may be useful when loosening the Uplink Module thumb screws. You should also have any cables required for connecting the Uplink Module to other network devices. 3. If connected, disconnect the switch unit from the redundant power supply. 4. Disconnect the switch unit from the mains power supply.
Quick Install Guide 5 7. Slide the Uplink Module into place. Make sure that the module is aligned with the card guides on each side of the bay (see Figure 2). Figure 2: Installing an Uplink Module. Card Guide A ACTIVITY AT-A35/S TX LINK X RX ACTIVITY B FULL DUP HALF DUP LINK COL COL 1000BAS E-FX/SC FULL DUP COL HALF DUP 8. Secure the Uplink Module to the switch unit. Firmly press the Uplink Module until its connectors engage the uplink bay connectors inside the switch unit.
Uplink Module Table 2: Uplink Module LEDs (AT-A39/T) LED State Function Full Dup/Half Dup/Col Green The port is operating at full-duplex Amber The port is operating at half-duplex Flashing amber Collisions are occurring Off No link is present Green A 1000 Mbps link is open Flashing green 1000 Mbps activity is occurring Amber1 A 100 Mbps link is open Flashing Amber1 100 Mbps activity is occurring Off No link is present Activity Early versions of the AT-A39/T operate at 1000 Mbps on
