Installation Guide
Table Of Contents
- Contents
- Preface
- Chapter 1
- Chapter 2
- Installing the Access Point
- Reviewing Safety Precautions
- Unpacking the Access Point
- Attaching the Ground Cable to the Access Point
- Connecting the Access Point with the Ethernet Cable
- Attaching the Antennas to the Access Point
- Installing the Access Point on a Wall
- Installing the Access Point on a Pole
- Starting the Initial Management Session on the Access Point
- Setting the Country Setting
- Installing the Access Point
- Appendix A
Chapter 2: Installing the Access Point
41
Note
A Phillip-head screwdriver is not included in the shipping box.
10mm socket and ratchet or adjustable wrench (for adjusting the
position of the access point)
Installing the
Access Point on a
Pole
To install the access point on a pole, perform the following procedure:
1. Review “Guidelines for Pole Installation” on page 40.
2. Attach the pole mount brackets to the pole with two U-bolds. See
Figure 17.
Figure 17. Attaching the Pole-Mount Brackets to the Pole
3. Attach the access point to the pole-mount bracket with the screws
using a Phillips-head screwdriver. See Figure 18.
Note
Attach the ground cable to the access point before attaching the
mounting base to the access point. Refer to “Attaching the Ground
Cable to the Access Point” on page 30.
Draft 5 on February 14, 2019