Installation Guide
Table Of Contents
- Contents
- Preface
- Chapter 1
- Chapter 2
- Installing the Access Point
- Reviewing Safety Precautions
- Unpacking the Access Point
- Attaching the Ground Cable to the Access Point
- Connecting the Access Point with the Ethernet Cable
- Attaching the Antennas to the Access Point
- Installing the Access Point on a Wall
- Installing the Access Point on a Pole
- Starting the Initial Management Session on the Access Point
- Setting the Country Setting
- Installing the Access Point
- Appendix A
AT-TQ5403e Outdoor Wireless Access Point Installation Guide
40
Installing the Access Point on a Pole
The AT-TQ5403e access point can be mounted on a vertical pole or
horizontal pole. see Figure 16.
Note
The pole mount bracket is angle-adjustable.
Guidelines for
Pole Installation
Review the following guidelines before installing the access point on a
wall:
The pole mount bracket has two hex-head bolts that allow you to
adjust the position of the access point upward or downward.
The access point must be installed the front panel down as shown in
Figure 16.
Figure 16. Pole Installation of the Access Point
What to Prepare
for Pole
Installation
You need the following items to install the access point on a pole:
AT-TQ5403e Access Point
Pole mount bracket
Four sets of screws, spring washers, and washers for the pole
mount bracket
Two U-bolds
Phillips-head screwdriver
Draft 5 on February 14, 2019